Camera Interfaces

TL 6636 USB 3.0 Interface, Vertical with Trigger

The TL6636 USB 3.0 interface board from AIVION is a tiny and easy to use HDTV USB3.0 video capture interface for the block cameras. The module receives digital video signals and sends UVC (USB Videl Class) compliant data packets to a connected host computer. Our compact TL6636 module enables the design of small camera systems that need only a single connection between camera and PC. Video stream, control data and power will be connected by a USB 3.0 cable. For camera blocks that need more than 900 mA during startup a Y-cable is required.

Datasheet TL6036

Features

  • Ext. Trigger w. MP2030M-GS
  • Aut. Trigger w. MP2030M-GS
  • Provides a small size, easy to use HDTV USB 3.0 compliant video streaming capture solution
  • Up to 1080p30 uncompressed HDTV video data, 4:2:2 YUV format
  • The module receives digital video signals at the input and sends UVC (USB Video Class) compliant data packets containing digital video payload to a connected host computer
  • Operates always as Super Speed USB3.0 device (Host or OTG operation modes are not supported)
  • Host computer must run a UVC capable operating system (e.g. Microsoft Windows 7)
  • Parallel up- and downstream of camera control and status data is possible (USB CDC)
  • The input supports multiplexed LVDS based video data
  • Full USB bus powered camera solution possible depending on camera
  • Power supply voltage for camera is generated onboard

Supported Video Standards

The following HDTV video standards are supported by the TL6636. Note that video standard availability is always dependent on the capability of the camera block used. As interlace video modes are not supported, make sure to set camera to any supported progressive video mode to enable correct video image data transmision to any host PC.

  • 1920x1080p @ 25Hz, 29.97Hz, 30 Hz
  • 1280x720p @ 50Hz, 59.94Hz, 60Hz, 25Hz, 29.97Hz, 30Hz

Blockdiagram TL6636

TL6036 Blockdiagram
Blockdiagramm TL6636

TL6636 MP2030M-GS Camera Evaluation Kit

Partnumber: TL6636-EVK-MP2030M-GS

The camera evaluation kit contains all items to easily connect camera, interface & monitor. Ready to evaluate the camera in minutes rather than hours.

Parts:

  • Tamron MP2030M-GS Camera
  • USB 3.0 Board (TL6636)
  • 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm (TLCK-K30-200)
  • Power supply and control interface board (EK-PA1100-USB)
  • 5 V AC to DC external power supply with interchangeable blade kit for USA, Europe, United Kingdom and Australian. (PS-TE10A05)
  • USB to serial adapter (TL-EVK-USB-SA)
  • Bracket and screws (TL-EVK-BRA)
  • USB 3.0 Cable with a USB 3.0-A male and a USB 3.0 micro-B male connector
    (TL-EVK-USB3.0-A-microB)
  • AIVION Visca Camera Control Software

The TL6636 USB Interface with Trigger supports following HD Cameras:

  • Tamron Block Cameras

Tamron Module Cameras

Name MP2030M-GS
Datasheet MP2030M-GS
Video Output Digital LVDS
Video Output Analog Analog VBS
Camera Control Interface Visca Protocol
Effectiv numbers of Pixels Approx. 3,190,000 pixels
Image sensor 1/1.8 type Global shutter SONY IMX265LQR-C CMOS (Progressive Scan)
Signal system (HD) 1080p/60, 1080p/59.94, 1080p/50, 1080p/30, 1080p/25, 1080i/60, 1080i/59.94, 1080i/50, 720p/60, 720p/50
Lens 30x optical zoom Nominal Value: f = 6.5 mm - 195 mm F1.6 to F5.3
Horizontal viewing angle (wide to tele) 54 degrees to 2.0 degrees
Digital Zoom 16x

TL6636 Evaluation Kit

Partnumber: TL6636-EVK

The evaluation kit contains all items to easily connect camera, interface & monitor. Ready to evaluate the camera in minutes rather than hours.

Parts:

  • USB 3.0 Board (TL6636)
  • 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm (TLCK-K30-200)
  • Power supply and control interface board (EK-PA1100-USB)
  • 5 V AC to DC external power supply with interchangeable blade kit for USA, Europe, United Kingdom and Australian. (PS-TE10A05)
  • USB to serial adapter (TL-EVK-USB-SA)
  • Bracket and screws (TL-EVK-BRA)
  • USB 3.0 Cable with a USB 3.0-A male and a USB 3.0 micro-B male connector
    (TL-EVK-USB3.0-A-microB)
  • AIVION Visca Camera Control Software

TL6636 Production Kit

Partnumber: TL6636

Production kit with all items needed for production. Powerful, cheap , competitive

Parts:

  • TL6636 Board
  • 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm (TLCK-K30-200)

Camera connecting cable

Partnumber: TLCK-K30-200

KEL USL cable for the TL6636 interface board

Parts:

  • 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm