Camera Interfaces
TL4K1171 6G-SDI Interface for Block Cameras
6G-SDI Transmitter Interface Block Cameras
The TL4K1171 is a small form factor serial digital video (SDI) transmitter from AIVION. Camera video input signals are equalized, processed and output over coaxial connectors. 6G-SDI output is compliant to SMPTE ST2081-10 MODE 1 mapping, Dual Link 3G-SDI output is compliant to SMPTE ST425-3, 2si mapping and 3G-SDI FHD output is compliant to SMPTE ST425-1 level A standards. Camera control is accomplished by a transparent full duplex communication channel. Physical interface between camera and camera controller / PC is based on RS232 or 3.3V TTL level. TLCK-B cable kit is available as accessory.
Features
- Video output up to Ultra High Defnition
- Resolution up to 3840x2160p @ 30fps
- Seamless connection to Sony FCB-ER8550, FCB-ER8530, FCB-ER8300 and FCB-ES8230 4K camera blocks and to new Sony FCB-EW9500H camera block
- 6G-SDI output of UHD formats
- Dual Link 3G-SDI output of UHD formats
- 3G-SDI output of FHD formats
- Automatic format detection
- Native signal processing for highest image quality
- MCX 75 Ohm straight coaxial connectors
- RS232 and 3.3V TTL level serial camera control interface
- External sync interface for FCB-ER8550
- Supply voltage 9V to 12V DC regulated
Quick Specification
- FCB-ER/ES/EW series interface on 30pin microcoax connector
- Up to 4K 3840x2160@30fps SDI video output
- Supply voltage 9V to 12V DC
- Operating ambient temperature range -5°C to +60°C
- Operating humidity range 20% to 80%
- Power consumption 3.9W with 12V DC supply voltage
- Power consumption 7.0W with 12V DC supply voltage incl. FCB-ER8530 series camera block
- Board size (L x W) 46mm x 60mm
- Wire/cable kit for camera and external interconnect
- RoHS compliant (2002/05/EG and 2011/65/EU)
- UL/UR compliant
Blockdiagram TL4K1171
The TL4K1171 Dual Link 3G-SDI interface supports the Sony FCB-ER8300 Camera
| Model | Video output | Camera control interface | Image Device | Effective Pixels | Horizontal Viewing Angle | Lens Value |
| FCB‑ER8300 | Minimum Illumination Color: 0.75 lx (F1.8, AGC on, 1/30 s) High Sensitivity Mode Color: 3 lx (F1.8, AGC on, 1/30 s) Normal Mode | VISCA (CMOS 3.1 V level) Baud rate: 9.6 Kbps, 19.2 Kbps, 38.4 Kbps, 57.6 Kbps, 115.2 Kbps, Stop bit: 1 bit | Progressive scan CMOS Image Sensor 1/2.3 type "Exmor R" | Approx. 8.93 Mega Pixels | 73.4° (wide end) to 6.4° (tele end) | 12x optical zoom, f = 3.9 mm (wide) to 46.8 mm (tele), F1.8 to F2.0 |
| FCB‑ER8530 | Digital Y/Cb/Cr 4:2:2 8 bits component, R/G/B 4:4:4 8bits component, similar to CEA-861-F HDMI1.4b | VISCA protocol (CMOS 3.1V) | 1/2.5-type Exmor CMOS | 8.51 MPixels | Approx. 70.2 degrees (Wide end, Image stabilizer Off), Approx. 4.1 degrees (Tele end, Image stabilizer O) | 20x optical zoom, f = 4.4 mm (Wide), 88.4 mm (Tele), F2.0 to F3.8 |
| FCB‑ER8550 | Digital Y/Cb/Cr 4:2:2 8 bits component, R/G/B 4:4:4 8bits component, similar to CEA-861-F HDMI1.4b | VISCA protocol (CMOS 3.1V) | 1/2.5-type Exmor CMOS | 8.51 MPixels | Approx. 70.2 degrees (Wide end, Image stabilizer Off), Approx. 4.1 degrees (Tele end, Image stabilizer O) | 20x optical zoom, f = 4.4 mm (Wide), 88.4 mm (Tele), F2.0 to F3.8 |
| FCB‑ES8230 | Digital Y/Cb/Cr 4:2:2 8 bits component, R/G/B 4:4:4 8bits component, similar to CEA-861-F HDMI1.4b | VISCA protocol (CMOS 3.1V) | 1 type Exmor CMOS | 20.47 MPixels | approx. 64.6 degrees (Wide end, Image stabilizer Off) Approx. 6.1 degrees (Tele end, Image stabilizer Off) | 12x optical zoom, f = 9.3 mm (Wide), 111.6 mm (Tele), F2.8 to F4.5 |
| FCB‑9500H | Digital Y/Cb/Cr 4:2:2 8 bits component, R/G/B 4:4:4 8bits component, similar to CEA-861-F HDMI1.4b | VVISCA protocol (CMOS 3.3V Level, 5.5V tolerance); Baud Rate : 9.6 kbps, 19.2 kbps, 38.4 kbps, 115.2 kbps, Stop bit: 1 bit | 1/1.8-type STARVISTM CMOS Sensor | 4.17 MPixels | 58.1° to 2.3° | 30x Enhanced Optical Zoom 36x StableZoom *2 *3 12x Digital Zoom |
| FCB‑9500L | Digital : Y/Pb/Pr 4:2:2 (LVDS) (Y: 8 bit, C: 8 bit, Vsync, Hsync, Field, Clock) (SMPTE274M/SMPTE296M) | VISCA protocol (CMOS 3.3V Level, 5.5V tolerance); Baud Rate : 9.6 kbps, 19.2 kbps, 38.4 kbps, 115.2 kbps, Stop bit: 1 bit | 1/1.8-type STARVISTM CMOS Sensor | 4.17 MPixels | 58.1° to 2.3° | 30x Enhanced Optical Zoom 36x StableZoom *2 *3 12x Digital Zoom |
TL4K1171 Sony FCB ER-8300 6G-SDI Camera Evaluation Kit
Partnumber: TL4K1171-EVK-Sony-FCB-ER8300
The camera evaluation kit contains all items to easily connect camera, interface & monitor. Ready to evaluate the camera in minutes rather than hours.
Parts:
- Sony FCB ER-8300
- 6G-SDI Board (TL4K1171)
- Base cable kit (TLCK-B):
- 10 pin flying leads cable for power and control(RS232/TTL), length 15cm
- 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm
- Power supply and control interface board (EK-PA1100)
- 12 V AC to DC external power supply with interchangeable blade kit for USA, Europe, United Kingdom and Australian. (PS-TE10A12)
- USB 2.0 Cable with a USB 2.0-A male and a USB 2.0 micro-B male connector (TL-EVK-USB2-A-MICROB)
- Bracket and screws (TL-EVK-BRA)
- 2 MCX to BNC connector cable (CK-MCX-BNC)
TL4K1171 Sony Sony FCB ER-8530 6G-SDI Camera Evaluation Kit
Partnumber: TL4K1171-EVK-Sony-FCB-ER8530
The camera evaluation kit contains all items to easily connect camera, interface & monitor. Ready to evaluate the camera in minutes rather than hours.
Parts:
- Sony Sony FCB ER-8530
- 6G-SDI Board (TL4K1171)
- Base cable kit (TLCK-B):
- 10 pin flying leads cable for power and control(RS232/TTL), length 15cm
- 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm
- Power supply and control interface board (EK-PA1100)
- 12 V AC to DC external power supply with interchangeable blade kit for USA, Europe, United Kingdom and Australian. (PS-TE10A12)
- USB 2.0 Cable with a USB 2.0-A male and a USB 2.0 micro-B male connector (TL-EVK-USB2-A-MICROB)
- Bracket and screws (TL-EVK-BRA)
- 2 MCX to BNC connector cable (CK-MCX-BNC)
TL4K1171 Sony Sony FCB ER-8550 6G-SDI Camera Evaluation Kit
Partnumber: TL4K1171-EVK-Sony-FCB-ER8550
The camera evaluation kit contains all items to easily connect camera, interface & monitor. Ready to evaluate the camera in minutes rather than hours.
Parts:
- Sony Sony FCB ER-8550
- 6G-SDI Board (TL4K1171)
- Base cable kit (TLCK-B):
- 10 pin flying leads cable for power and control(RS232/TTL), length 15cm
- 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm
- Power supply and control interface board (EK-PA1100)
- 12 V AC to DC external power supply with interchangeable blade kit for USA, Europe, United Kingdom and Australian. (PS-TE10A12)
- USB 2.0 Cable with a USB 2.0-A male and a USB 2.0 micro-B male connector (TL-EVK-USB2-A-MICROB)
- Bracket and screws (TL-EVK-BRA)
- 2 MCX to BNC connector cable (CK-MCX-BNC)
TL4K1171 Sony Sony FCB ES8230 6G-SDI Camera Evaluation Kit
Partnumber: TL4K1171-EVK-Sony-FCB-ES8230
The camera evaluation kit contains all items to easily connect camera, interface & monitor. Ready to evaluate the camera in minutes rather than hours.
Parts:
- Sony Sony FCB ES-8230
- 6G-SDI Board (TL4K1171)
- Base cable kit (TLCK-B):
- 10 pin flying leads cable for power and control(RS232/TTL), length 15cm
- 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm
- Power supply and control interface board (EK-PA1100)
- 12 V AC to DC external power supply with interchangeable blade kit for USA, Europe, United Kingdom and Australian. (PS-TE10A12)
- USB 2.0 Cable with a USB 2.0-A male and a USB 2.0 micro-B male connector (TL-EVK-USB2-A-MICROB)
- Bracket and screws (TL-EVK-BRA)
- 2 MCX to BNC connector cable (CK-MCX-BNC)
TL4K1171 Sony Sony FCB EW9500H 6G-SDI Camera Evaluation Kit
Partnumber: TL4K1171-EVK-Sony-FCB-EW9500H
The camera evaluation kit contains all items to easily connect camera, interface & monitor. Ready to evaluate the camera in minutes rather than hours.
Parts:
- Sony Sony FCB EW9500H
- 6G-SDI Board (TL4K1171)
- Base cable kit (TLCK-B):
- 10 pin flying leads cable for power and control(RS232/TTL), length 15cm
- 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm
- Power supply and control interface board (EK-PA1100)
- 12 V AC to DC external power supply with interchangeable blade kit for USA, Europe, United Kingdom and Australian. (PS-TE10A12)
- USB 2.0 Cable with a USB 2.0-A male and a USB 2.0 micro-B male connector (TL-EVK-USB2-A-MICROB)
- Bracket and screws (TL-EVK-BRA)
- 2 MCX to BNC connector cable (CK-MCX-BNC)
TL4K1171 Evaluation Kit
Partnumber: TL4K1171-EVK
The camera evaluation kit contains all items to easily connect camera, interface & monitor. Ready to evaluate the camera in minutes rather than hours.
Parts:
- Sony Sony FCB EW9500H
- 6G-SDI Board (TL4K1171)
- Base cable kit (TLCK-B):
- 10 pin flying leads cable for power and control(RS232/TTL), length 15cm
- 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm
- Power supply and control interface board (EK-PA1100)
- 12 V AC to DC external power supply with interchangeable blade kit for USA, Europe, United Kingdom and Australian. (PS-TE10A12)
- USB 2.0 Cable with a USB 2.0-A male and a USB 2.0 micro-B male connector (TL-EVK-USB2-A-MICROB)
- Bracket and screws (TL-EVK-BRA)
- 2 MCX to BNC connector cable (CK-MCX-BNC)
TL4K1171 Production Kit
Partnumber: TL4K1171
Production kit with all items needed for production. Powerful, cheap , competitive. Additional Connector Options(MOQ) are available.
Parts:
- 6G-SDI Board (TL4K1171)
- Base cable kit (TLCK-B):
- 10 pin flying leads cable for power and control(RS232/TTL), length 15cm
- 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm
Base Cable Kit
Partnumber: TLCK-B
Cable kit for the TL4K1171 interface board
Parts:
- 10 pin flying leads cable for power and control(RS232/TTL), length 15cm
- 30 pin KEL USL type micro coaxial cable, connector on both sides, length 20cm
